Dont worry about the error message appeared since it is open docx office 2003 only mentioning that the boot file has been acrobat pro x won't open windows 7 copied.
Please make sure before this installation, you will need 2 identical hard disk with same space connected to the server.Here's how to do it: Click, start, click, run, type regedit, and then click.Gee, setting up an sntp/NTP server in Windows is not intuitive.For Windows Server 2003 R2, content includes Installation, Product Evaluation, Getting Started, Planning and Architecture, Deployment, and content included in the product.But for beginner, it is better to get a hard disk that got the same space quantity, less percentage that you would get yourself confused.Just wait for a while till it finished: 13) Once the synchronization has been done, this will be the final outlook of your hard disks appearance: That is all on how to setup Software raid on Windows Server 2003.Complete set of content formerly published at Windows TechNet for Windows Server 2003, Server 2003 Service Pack 1 and 2, and Windows Server 2003.Right click on the Disk 0 (which contains the operating system) and select Add Mirror (which is similar to raid1, whereas the Extend Volume option is similar to raid0) : 11) Now select the 2nd hard disk that you want to add as its mirror.10) Once the reboot done, open back the Computer Management and this time you can see both hard disks are labeled as Dynamic.In the, edit dword Value dialog box, type 1 under, value data, and then click.
This should get you setup with minimal registry hack impact.
Today Im going to show how to setup for Windows Server 2003.
Locate and then click the following registry entry: in the right pane, right-click, announceFlags, and then click.
But this time, it will not be based on Linux or Unix operating system.
Select Manage and click on it: 3) Next is to select Disk Management: 4) Right-click on your current hard disk that contained the Windows and select Convert To Dynamic Disk: 5) Select the hard disk that you want to convert.
Below are the steps on how to enable the Software raid inside Windows Server 2003: 1) You may follow the initial windows setup here: 2) After the installation has finished, click on Start button and right-click on My Computer.Today Im going to show you on how to setup a software raid as usual.Tips, make sure W32Time is set to Automatic startup mode.Click the Yes button to proceed: 8) Click Yes again to proceed: 9) After the conversion has been done, the system will go for a reboot.At the command prompt, type the following command to restart the Windows Time service, and then press enter: net stop w32time net start w32time.Locate and then click the following registry subkey: in the right pane, right-click, enabled, and then click.Yes, Windows Server 2003 has a built-in function that almost similar to Software raid function.Use this, internetTime program to help you debug connectivity to your sntp/NTP server.Make sure UDP 123 is allowed through your firewall.